职位搜索
Production Process Engineer/工艺工程师
发布日期: 2018-06-04 工作地点: 无锡-锡山区
工作年限: 5-7年 学    历: 本科

职位描述:

Mission:

---Process PTM as in P1,P10 and P0 project

--Works together with industrial project leader for the industrialization of products following IPROM in project phase and procedure and V5000 Roadmaps.

--And in mass production help production line to deliver good products and improve productivity


Responsibilities:

Industrial project (industrial leader focus on industrialization of the line, tooling and machine, and process engineer focus on technique)


Design Freeze

No critical RPN without countermeasures by delivery Process FMEA status and Control Plan

Validated with 70% and all mandatory's fulfilled by delivery Lean Process Design Checklist results

TOOL Go

Updated and no critical RPN without counter measures by delivery Process FMEA status

Issued List of process SPPC

OFF TOOL

Team training tracking sheet by delivery Off Tool product build done by production team

Validated with 70% and all mandatory's fulfilled by delivery Lean Process Design Checklist results

OFF TOOL OFF PROCESS

SQCDM as good as before transfer

Trial Runs done

Maturity in line with Customer Requirement and FDPR preparation according to procedure (ppm, kosu, capabilities targets, ...)

Completed and no critical RPN by delivery Process FMEA status

Validated with 70% and all mandatory's fulfilled by delivery Lean Process Design Checklist results

IS Validation

FDPR accepted / Process qualified by delivery FPDR reports and action plan including Process Validated.

Training / Certification of operators and technicians by Team Magic Square

SOP readiness

Support industrial leader to Final acceptance report for line&machine

Delivered on time with right maturity level for Pre-series parts

Line QRQC active during Production ramp up

Capacity demonstrated for Ramp-up Plan

Appropriate Magic Square status for Ontime production staffing and training

Validated with >80% for Lean Process Design Checklist results

Initiated A PFMEA on Gemba is performed to identify risks or opportunities that may not be listed in the PFMEA/ DFMEA/ LFMEA.

Project Closure

Completed Equipment documentation & program updated & backed-up, updated or new RAISE standards

Transfer checklist, mechanical, pneumatics, hydraulics drawings, software backup, logic programming diagram, database (LCC, KC, Good practices…), user manual, maintenance manual

Completed improvement plan and Capacity confirmation with capacity sheet


Non Industrial project (no industrial project leader),VS industrial project, some additional task as below by process engineer


Project Kick-off

Project targets and project planning

KPIs target confirmation

Restate the project scope and milestones,

Restate all stakes, Target and responsibilities of the project team

Requirement Freeze

LPDC assessment.

Identify novelties on customer‘s requirements and on our technical solution, risks that have to be raised before requirement freeze.

Design Freeze

Functional specification completed

No critical RPN without countermeasures. For Process FMEA status and Control Plan

IAR

updated Detailed process specifications

updated Detailed investment plan

Capacity / Generic investment

IAR

TOOL GO

Suppliers Orders / IVC outcome

Equipment suppliers nomination letters

Mold manufacturing sheets

OFF TOOL

Process equipment realization, 1st part manufactured by the equipment at supplie

SOP Readiness

Final acceptance report for line&machine


Qualification:

- Bachelor degree in engineering, mechanical engineering or relevant

-Fluent English

立即申请
返回职位列表